hostpinoy.blogg.se - Why wont telnet connection work on n1mm logger

#Why wont telnet connection work on n1mm logger series#

Slice Master 6000 is not just for managing other third party programs. Likewise, changing the frequency of a slice receiver will cause the Clicking on a signal in CW Skimmer, forĮxample, will cause the associated slice receiver to change frequency. Two way communication between Slice Master 6000 and the programs it So long as its panadapter is assoicated with the necessary resources. A program instance can be launched for any active slice Launching third party programs to work with the slice receivers in Slice Master 6000's primary focus is on dynamically configuring and

solo, mute, agc, sidetone, monitor, and level presets.

Telnet clusters, CCuser, SpotCollector, HRD Logbook, and Logger32Ĭolors spots with N1MM Logger+ multipliers, or "needed status" fromĪggregates CW Skimmer, GRITTY, WSJT-X, JTDX, JS8Call spots into a single telnet connection Supports per slice and TX following HRD TCP client connections Supports per slice and TX following CAT over TCP client connections Synchronizes slice and panadapter attributes between slices

displays spot data from CW Skimmer, GRITTY, WSJT-X, JTDX, JS8Call, N1MM Logger+,.

CW Skimmer, GRITTY, DM780, WSJT-X, flDigi, JTDX, JS8Call.

Features Configures and launches multiple third party applications automatically

#Why wont telnet connection work on n1mm logger series#

Take control of your Flex 6000 series radio's slice receivers with Slice Master 6000. Ok, Now with your explanations, I understand why there is nothing on display.Slice Master 6000 version 0.10.8 Donald Beaudry (K1DBO).If there is no RX frequency information, the spectrum data is labelled with audio baseband frequencies (0-3 kHz), and the N1MM+ spectrum window will not display it. When CW Skimmer is used in "3-kHz receiver" mode using the direct audio output from a receiver, it normally gets the frequency information via a rig control (CAT) connection to the receiver. Regarding rig control: the spectrum source (CW Skimmer) needs to know what frequency the SDR is tuned to in order to label the spectrum data it sends to N1MM+. It was just to do a quick test with no radio but it was not a good idea. This will not result in a very useful spectrum display, since the only signals displayed will be those within that narrow 3 kHz bandpass. As far as I am aware, the output from a WebSDR is baseband audio, about 3 kHz wide. You mentioned WebSDR (presumably for non-contest use). => It means that Network, CW Skimmer and N1MM config seams OK.ICMP messages type 3 (Port unreachable) are sended after each UDP packet when data source not specified in N1MM Spectrum Display config.II saw that hte UDP data flow exist only when the Start/Stop Radio Button of CW Skimmer is started.For information, I checked the N1MM UDP connexion on CW Skimmer with a Dataflow capture on the localhost with Rawcap.exe and analyzed with Wireshark.After you have connected to the source successfully and exited from the program normally in order to save the configuration file, the name of the source should be remembered in future". "Sometimes, the first time you use a new spectrum source you may need to type the name of the source into the "source named" box. 73, Rich VE3KI toggle quoted messageShow quoted text

After you have connected to the source successfully and exited from the program normally in order to save the configuration file, the name of the source should be remembered in future. Sometimes, the first time you use a new spectrum source you may need to type the name of the source into the "source named" box.